This time I'll make an rc racing boat made out of foam board. This boat is capable of reaching high speeds, in this video, you'll see the entire process and the struggle of building something I don't ...

5V, GND (2 pin) 2x CAN for debug (1 for each interface) (4 pin) RGB LED (3 GPIO to control) (3 pin) I/O (11 pin) 15x RC-Servo output: connecteur 3pin 2.54mm standard (+,-,signal). use PWM if available ...

3-wire connector from Servo -> yellow into pin 10 through a 220Ω resistor, red into 5V rail of breadboard, brown into GND rail of breadboard. ~470 µF capactior across +5V and GND near the servo to ...